At outside temperature of less than 5° degrees the ORACOVER® FOAM ADHESIVE can only be shipped in special temperature controlled boxes. The costs will be charged to the customer. We can provide you with the current prices upon request.
ORACOVER® FOAM ADHESIVE for Styrofoam / Depron
Models made of Styrofoam / Depron are coated with ORACOVER® FOAM ADHESIVE, in the areas to be covered. Before coating make sure the surface is as smooth as possible, as any faults or roughness will show later on. For coating we recommend using a brush made of artificial fibres, to prevent the brush soaking up water from the adhesive and the adhesive forming little lumps when drying. Let dry thoroughly before covering. Following, iron or stick ORACOVER® / ORASTICK.
Use a test piece of foam to get the feel of the material. If reworking with the iron is necessary make sure the iron temperature does not exceed 95°C as more heat may cause damage to the foam surface.
Due to heating to approx. 80°C you can remove the film without damaging the surface (for repairing purposes).
Safety Data Sheet: Download
* Our offer is aimed at final consumers. Therefore, all quoted prices include 19 % German VAT. Transport costs will be charged on top of that.
Pictures may differ from the original products. We cannot assume any liability for the product information given. Accessories shown in the pictures are not included in the delivery. The trademarks mentioned on this website and in our advertising materials, e.g. ORACOVER, ORASTICK, ORALIGHT, ORALINE, ORATRIM, EASYCOAT, EASYPLOT, ORATEX, CARBON are registered trademarks, the use of which is reserved exclusively to Lanitz Prena Folien Factory. All other logos, descriptions and trademarks are property of the respective manufacturer. Subject to change and prior sale. Errors excepted.